DIY projects allow you to achieve the result that you desire. Utilizing your skills and artistic talents is related to this matter, and it’s also a way to save some bucks. With regards to this, many boaters can manage how to build a boat bench seat by themselves.

You may have wood for building boat seats. Some upgrades can be done by adding cushion and vinyl. Once you choose a design, you can start collecting materials.

If you’re groping for design ideas, this article will show you DIY boat bench seats that will surely please you. You can follow them to refurbish or renovate a boat.

Various boat styles showcase different angles and lines. Wide and deep hulls are the main characteristics of workboats, while sailboats are thin and long. Nonetheless, a wooden banquette would be fantastic on both of these vessels. Here are the steps:

Step 1. Take off Metal and Trim

A banquette is a bench along the wall. Therefore, you have to consider the needed space and shape for it. The center section of the boat is where you need to lay down this project.

To get started, you have to remove metal or trim but you must keep the pieces for reconnection later on. You may also need to take off logos and insignias that are still useful.

Step 2. Cutting the Chosen Area

Use chalk to draw a line on your chosen area then you can run the chainsaw over it. Cutting the area should be even and consistent. You may need to tidy up the cutting with a circular saw.

You have to be attentive while doing it as there may be some screws. These tiny pieces of hardware may be hiding underwood plugs.

Step 3. Cleaning

Get rid of the debris created by cutting since it can block from cutting the bottom part.

Step 4. The Bench Base

Use two pieces of 2×4 wood and place them 16 inches above the pontoon boat furniture with the support from screws for wood. This step is not only for building the base but hull reinforcement as well.

Get ¾-inch plywood to be added over the 2×4 woods with screws. This will strengthen the structural integrity that may have temporarily gone due to the cuttings that were made.

Step 5. Seat Back

You may recycle some wood that just lay around or V-groove soffit panels. Get measurement from the seat to the boat anchor for the preparation of the seatback.
http://www.allshinemarine.com/pontoon-boat-furniture/